FAS800
800 Wheel Horsepower. Factory Drivability. No Compromise.
The FAS800 is the entry point into the FAS performance ecosystem — a fully documented, street-drivable 800 WHP build engineered for the Hellcat supercharged platform. Pulley upgrades, custom calibration, and in-house validation. No tune-and-hope. Every car is verified before release.
What's Included
Every FAS800 build follows the same validated build sheet. No shortcuts. No outside shops.
- Pulley Upgrade Package
Platform-matched smaller lower pulley for increased supercharger boost pressure.
- Cooling Modifications
Thermal management upgrades to support sustained power output under load.
- ECU Unlock
Factory ECU unlocked to accept the FAS custom calibration tune.
- Full Custom Performance Tune
Live calibration built specifically for your vehicle. FAS technicians perform pull runs while a professional remote tuner modifies the calibration files in real time. Not an off-the-shelf file.
- Installation Labor
Complete bolt-on installation at our Punta Gorda, FL facility by FAS technicians.
Platform Variants & Pricing
The FAS800 build is available for three Hellcat-based platforms. Same power target. Same final verification. Same FAS standards.
| Platform | Price | Power Target | Fuel | Action |
|---|---|---|---|---|
| Charger & Challenger | $6,499.00 | 800 WHP | 91–93 Oct | Schedule → |
| Trackhawk / Durango SRT | $6,599.00 | 800 WHP | 91–93 Oct | Schedule → |
| RAM 1500 TRX | $6,699.00 | 800 WHP | 91–93 Oct | Schedule → |
Note: Vehicle not included with purchase. Installation service requires vehicle drop-off at our Punta Gorda, FL facility. Modifying your vehicle may affect factory warranty. Compare FAS850 →
The Build Process
From intake to final inspection, every step is handled in-house at our Punta Gorda facility.
- Coordinate & Drop Off
Contact FAS to confirm platform compatibility and schedule your build slot. Drop your vehicle at 6161 Riverside Dr, Punta Gorda, FL 33982.
- Pre-Build Assessment
Your vehicle's baseline condition is logged and documented before any work begins. Platform fit is confirmed and the build scope is finalized.
- Full Installation
Pulley swap, cooling modifications, and ECU unlock performed by FAS technicians using our validated build sheet for your specific platform.
- Live Tuning Session
FAS technicians perform pull runs on your vehicle while a professional remote tuner modifies calibration files in real time — adjusted for your specific engine, fuel system, and conditions. Not a generic file drop.
- Verification & Release
Final pull runs confirm the 800 WHP target is met. Datalogs are reviewed by the remote tuner. Your vehicle is not released until the numbers are right.
The FAS Performance Ladder
The FAS800 is built for future upgrades. Every tier uses the same baseline platform work — moving up costs less when you started right.
Common Questions
- Is this a parts kit or an installation service?
- This is a full installation service. You bring your vehicle to our Punta Gorda, FL shop and we handle the installation, calibration coordination, datalog review, and final verification.
- Does the FAS800 require E85 fuel?
- No. The FAS800 is designed to run on 91–93 octane pump gas. E85 conversion is available at the FAS900 tier and above.
- How is the tune developed and verified?
- FAS technicians perform pull runs on your vehicle while a professional remote tuner modifies calibration files in real time. Power targets are confirmed through pull-based testing before the vehicle leaves the shop. Not a mail-order tune.
- Can this be combined with other FAS parts in one order?
- Yes. Mixed carts are fully supported. You can bundle billet parts or intake upgrades with an installation package and check out in a single transaction.
Ready to Build?
Request your FAS800 build consultation. Every car is documented, checked, and released only after final verification.